Struggling with carburetor settings - I think!
Lets start by saying I am new at gas rc products.
I have an Enforcer Team Pro with a water cooled Zenoah 260 gas engine and a WT 488 carburetor. I have adjusted the High and Low needles richer and leaner and still have the same issue.
The problem is the engine keeps cutting out on me almost like it is missing. It does not do this all the time. At full throttle running in a straight line it seems to run fine. It is that ¼ , ½, and ¾ throttle it will cut out and then take off again. It never gets to the point were it stalls and it is not consistent. At first I thought it was the fail-safe I had in the boat because it is almost like the engine goes back to idle and then takes off again. I have removed the fail-safe and have the same problem. I also had the stock carburetor on the engine at first and had similar issues. I guess I am also a little confused on the range of the Low and High adjustments.
Does the low adjustment effect performance from idle to half throttle and does the High effect from half to full throttle?
Any suggestions on the engine cut out issue?